Hi,

today I got my new case. It has front Audio, USB and Firewire connections. The cardreader is also connected via USB.

Looking at the board and the (highly technical... ) documentation at Freescale, I was only able to figure out where to connect the audio wires (even though I don't know if it would be possible to fully use all channels since there are more connectors on the board but only 2 wires on two connectors used) and one USB. So, where can I find a detailed figure of the pins on the Pegasos2 board?

I also bought a Firewire/USB2 PCI card. It offers 1 USB and 1 Firewire connector within the computercase . Buuuuut: how can I connect those to the "wires only" connector of the case? OK, bad description - my english is too bad. But I hope you understand ("normal" USB/Firewire plug -> "wiresonly" plug like in the defautl AOpen case).

Are there any prebuilt adapters? Or will I have to solder them myself? :-/


Summary:

• - figure with description of connectors on the pegasos2 board
  - howto connect "default plugs" (usb/fw) with a wired connector?

Thanks!

PS: Sorry again for my stumbling english.

Did you not get a handbook with your Pegasos 2?
It describes all Pegasos connectors except the Gigabit expansion and the CPU slot.
At least the front panel connector description is available online.

User Manual (English, French, German):

http://www.pegasosppc.com/manuals/Pegas ... nglish.pdf

http://www.pegasosppc.com/manuals/Pegas ... French.pdf

http://www.pegasosppc.com/manuals/Pegas ... German.pdf

We need to add links to these on PegasosPPC.com and will.

R&B

Thank you!