AFAIR, Lenny also uses larger than 128 byte inode sizes, while the firmware only can work with 128 byte inodes. Workaround: format partitions before installation with:
Code:
-I 128
mke2fs parameter.
| Power Developer https://powerdeveloper.org/forums/ |
|
| Troubles with debian hdd in openfirmware Pegasos 2 https://powerdeveloper.org/forums/viewtopic.php?f=7&t=1804 |
Page 1 of 1 |
| Author: | XzIt [ Fri Apr 23, 2010 4:33 pm ] |
| Post subject: | Troubles with debian hdd in openfirmware Pegasos 2 |
Hi After almost 2 years of none linux use i finally decided to get the old linux hdd out of the box and into my Pegasos 2. Because i did some upgrades the last years i used up both my ide pluggs on the first ide port. So my only option was to put it one the second ide port , last plugg as slave after my dvd. I installed the newest debian from the vmlinuz-chrp.initrd (netinstall). Choose my hdd and made the partisions , "/" First as EXT3 and bootable then Swap. Finished that and installed my linux as choose not to use ther Grub Boot loader. Done, Rebooted and tried to list my /pci/ide/disk@1,1 it found EXT and the swap area. but when trying to do so one the EXT3 drive i get the error that its not there, when doing list again on the swap it gets no error or any response. plz help anyone and everyone =) XzIt |
|
| Author: | czp [ Sun Apr 25, 2010 10:15 am ] |
| Post subject: | |
AFAIR, Lenny also uses larger than 128 byte inode sizes, while the firmware only can work with 128 byte inodes. Workaround: format partitions before installation with: Code:
-I 128
mke2fs parameter.
|
|
| Author: | XzIt [ Tue Apr 27, 2010 6:01 am ] |
| Post subject: | |
Thx! That did the trick and its up and running again. XzIt |
|
| Page 1 of 1 | All times are UTC-06:00 |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|