Power Developer https://powerdeveloper.org/forums/ |
|
USB flash bootable image for EFIKA https://powerdeveloper.org/forums/viewtopic.php?f=7&t=1637 |
Page 1 of 1 |
Author: | vvucic [ Fri Nov 14, 2008 1:25 pm ] |
Post subject: | USB flash bootable image for EFIKA |
Did anyone try to boot up EFIKA from image that is USB flash bootable? Thanks, Vedran |
Author: | PurpleAlien [ Sat Nov 15, 2008 9:36 am ] |
Post subject: | |
Hi. Yes, I have done that a couple of times in the past. It's rather slow though, and in the end I settled for a IDE to CF adapter instead. Johan. |
Author: | vvucic [ Sat Nov 15, 2008 11:27 am ] |
Post subject: | USB flash bootbale image |
Can you post some details on how you were doing that. Did you use USB CF? Best wishes, vedran |
Author: | PurpleAlien [ Sat Nov 15, 2008 11:50 am ] |
Post subject: | |
Hi. Since the Gentoo Wiki lost their database, I can point you to their back-up: http://www.gentoo-wiki.info/Genesi_Efik ... _usb_stick This will help you find the right firmware commands. I still have my older Efika images here: http://robotics.puv.fi/efika/ (including a small one) You can extract these on a ext2 formatted USB flash drive. (you still need a kernel too, but I suppose you have one?) I still have an older kernel here: http://www.cc.puv.fi/~jd/kernel_efika/ Hope this helps. If you have any problems, don't hesitate to ask - I'll do what I can. Best regards, Johan |
Page 1 of 1 | All times are UTC-06:00 |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |