| Power Developer https://powerdeveloper.org/forums/ |
|
| EFIKA *NOT* PPC_52XX https://powerdeveloper.org/forums/viewtopic.php?f=25&t=1484 |
Page 1 of 1 |
| Author: | dev-menzi [ Wed Jan 30, 2008 1:11 pm ] |
| Post subject: | EFIKA *NOT* PPC_52XX |
After happily being able to compile a 2.6.19-kernel for the EEFIKA, using the tips from the "Efika OpenFirmare and Linux Howto", I had a look at the .config file which was in use for that process. Now I am puzzled after I found in file .config as well as in linux-2.6.19rc6_config: ... lines snipped # CONFIG_PPC_52xx is not set ... lines snipped Then later http://www.powerdeveloper.org/forums/vi ... php?t=1339 suggesting "zImage" as make target. My Question: Which then are the one switches, that tell the compiler to compile for an Efika-target? |
|
| Author: | PurpleAlien [ Wed Jan 30, 2008 10:39 pm ] |
| Post subject: | |
Hi. For the 2.6.19 kernel, you should just select "6xx/7xx/74xx" in "processor support", after which a menu "platform support" becomes available. There you can select the "bPlan Efika 5k2. MPC5200B based computer". Best regards, Johan |
|
| Author: | dev-menzi [ Wed Jan 30, 2008 11:42 pm ] |
| Post subject: | |
Thanks Johan! In File .config I can find right at the top: .... CONFIG_PPC_MERGE=y .... which apparently has to do with patch #0001 from the efika-patches. .... and further down: # # Platform support # CONFIG_PPC_MULTIPLATFORM=y .... CONFIG_PPC_CHRP=y CONFIG_PPC_EFIKA=y .... You're right: .... Must search it under Platform support ---> *RIGHT* .... rather than under Processor support ---> #WRONG# Our topic resembles the homo sapiens - erectus - neanderthalensis discussions! It's difficult to understand the genealogy ;-) Thanks again! |
|
| Page 1 of 1 | All times are UTC-06:00 |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|