All times are UTC-06:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Feb 28, 2006 7:34 am 
Offline

Joined: Mon Feb 27, 2006 4:51 pm
Posts: 11
Hi

I'd like to know it the EFIKA is limited to the use of 1 Slot RISER cards or if it's possible to use 2 Slot or even 3 Slot RISER cards too.
Think about using a VGA card together with an USB 2.0 or SATA controller card.


Top
   
 Post subject:
PostPosted: Thu Mar 02, 2006 6:59 pm 
Offline

Joined: Wed Feb 22, 2006 3:28 pm
Posts: 1
Hi

I can't speak for the Efika itself but the MPC5200 processor only supports 1 slot without an external arbiter/bridge chip. though you could probably make a riser card with one of ti's bridge chips on it. you would also have to work out pci slot interrupt configuration. Again I can only speak for the MPC5200 they may have put a bridge on the EFIKA board.

Good Luck


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC-06:00


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
PowerDeveloper.org: Copyright © 2004-2012, Genesi USA, Inc. The Power Architecture and Power.org wordmarks and the Power and Power.org logos and related marks are trademarks and service marks licensed by Power.org.
All other names and trademarks used are property of their respective owners. Privacy Policy
Powered by phpBB® Forum Software © phpBB Group