Power Developer • QNX is up and running

Unanswered topics | Active topics

Board index » »

All times are UTC-06:00

QNX is up and running

Post new topic Reply to topic

Page 2 of 2

[ 17 posts ]

Previous topic | Next topic

Author

Message

shakenfr

Post subject:

PostPosted: Fri May 16, 2008 8:06 am

Offline

Joined: Fri May 02, 2008 3:37 am
Posts: 14

Thanks for your answer.

It seems to be a little bit difficult to obtain this result. In addition you speak about the need of an "unreleased firmware" and modification to the lite5200BSP.

If it finally works, can we hope for an already made distribution for Efika one day. All the steps you describe are one time only made and we can suppose that it would be possible to obtain an archive of the result. It seems possible also because for non commercial use, end user can use QNX.

If that thing planned ? It can really be a good idea to have QNX for the Efika . I use QNX on a PC, it's quick, perfect for embedded hardware (as MorphOS).

Top

Profile

Reply with quote

knickels

Post subject:

PostPosted: Fri May 16, 2008 8:36 am

Offline

Joined: Tue Mar 20, 2007 3:05 pm
Posts: 26
Location: San Antonio TX

Quote:

Thanks for your answer.
If that thing planned ? It can really be a good idea to have QNX for the Efika . I use QNX on a PC, it's quick, perfect for embedded hardware (as MorphOS).

While I don't have any inside information on this, I think that's what's under the hood in the National Instruments offering (see earlier in this thread). I don't have one of these to play with (yet).

_________________
Kevin Nickels, Assoc. Prof, Trinity University, San Antonio, TX, USA